Bio-regeneration of p-complexation desulfurization adsorbents

More and more stringent regulations of gasoline and diesel oil were proposed with the awareness of environmental protection. Hydrodesulfurization (HDS) is a conventional method to remove sulfur compounds for industrial purpose. The main drawbacks of this …     

担载型铂催化剂上甲烷活化的TPSR研究

用程序升温表面反应手段，系统地考察了甲烷在Ｐｔ催化剂上的吸附活化特征及甲烷分解后产生的表面碳物种。结果表明，ＣＨ４确能在ＳｉＯ２担载型Ｐｔ催化剂表面发生解离吸附，生成复杂的碳物种。这些碳物种间可发生相互转化。     

聚苯乙烯型双季铵树脂的制备及性能研究

三乙烯二胺和四甲基乙二胺与氯甲基聚苯乙烯反应,得到同时含有季铵和叔胺的强-弱碱型树脂,再用碘甲烷季铵化叔胺,制备聚苯乙烯双季铵树脂;另一种方法是将二甲基苄胺型叔胺树脂用4-溴丁基三甲基溴化铵季铵化引入4碳链双季铵基团。反应结果表明,两类强弱碱基树脂的季铵化反应结果并不理想,二甲基苄胺型叔胺树脂季铵化反应的转化率最高为36%。考察了这些新型双季铵树脂的热稳定性及对水溶液中有机酸(如苯磺酸和对-硝基苯乙酸)的吸附、脱附性能。     

正交试验法优化CS汽化吸附条件

通过正交试验设计,优化了影响西埃斯(CS)标准样品管制备的参数:汽化温度、采样流速、采样时间。结果表明,CS标准样品管的最佳吸附条件为汽化吸附温度:260℃,采样N2流速:330mL/min,采样时间:15min。在15~1500ng范围内,色谱峰面积与进样量有良好的线性关系,线性相关系数为0.9995,检出限为6.0ng。     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

亲和标记-基质辅助激光解吸电离飞行时间质谱用于蛋白质相对定量方法的研究

将亲和标记技术和基质辅助激光解吸电离飞行时间串联质谱联用,建立了蛋白质相对定量方法,以牛血清白蛋白为实验对象,考察了该方法的准确度、重现性等指标;又以数种标准蛋白混合物为研究对象,考察了该方法的动态范围及相应的标准偏差,为实际生物样品中差异蛋白质分析奠定了基础。     

XPS,AFM, ATR and TPD evidence for terraced,dihydrogen terminated, 1×1 (100) silicon

Heating (100) silicon at high temperature (say, higher than 850 °C) in H₂, cooling to 670–700 °C in the same ambient, and quenching to room temperature in N₂ results in environmentally robust, terraced 1 × 1 (100) SiH₂. Evidence for this conclusion is based on angle‐resolved x‐ray photoelectron spectroscopy, atomic force microscopy, infrared absorption spectroscopy in the attenuated total reflection mode, thermal programmed desorption, and reflection high‐energy electron diffraction. Copyright © 2005 John Wiley & Sons, Ltd.     

FCC硫转移剂MgAlCuFe复合氧化物的结构与性能:金属盐前体的影响

分别以硝酸盐、盐酸盐和硫酸盐为金属盐前体,采用共沉淀法合成了MgAlCuFe类水滑石前驱体,经过700℃焙烧6h后,制得三种新型FCC硫转移剂.运用X射线衍射、热重、氮气吸附和红外光谱对这三种硫转移剂的结构和性能进行了表征,并采用改装的WRP-3热重天平评价了其氧化吸硫和还原脱硫的性能.结果表明,三种金属盐均可得到结构规整的类水滑石前驱体,经过焙烧后得到复合氧化物MgAlCuFe.与采用盐酸盐和硫酸盐作前体相比,由硝酸盐制得的硫转移剂具有较大的比表面积,其饱和吸附硫容和氧化吸硫速率均较高,6min可达到1.54g/g的饱和吸附能力,同时具有较强的还原脱硫能力.